The advantages of possessing a warm garage are especially noticeable in the autumn-winter period, when to store the car on an open parking becomes too troublesome: it is necessary to drive a car from the snowy "captivity", then to suffer with the cold start of the engine, then once again change the rusty and reversible time from Building details. While stored in the warm garage "Iron horse" is ready to go on the road at any time.
Create the optimal storage conditions for the car will help the installation of the sectional gates "Alutes" with increased energy efficiency indicators.
The secret of the conservation of heat from the group of companies "Alutech" is to combine 3 technological solutions:
Increased thickness of the sandwich panel
Imagine that instead of the gate, the brick wall is erected in the garage. 60 cm thick. Solid, is not it? Similar indicators of energy efficiency have a sectional gate "Alutech" from sandwich panels with a thickness of 45 mm. This is one of the thick and warm panels in the European market - the coefficient of resistance of the heat transfer of the gate of them is 1.0 m2 * ° C / W.
In addition, due to the increased thickness of the canvas, the ALUTEKH gates are able to withstand the wind gusts by speed up to 120 km / h, which is a significant advantage at any time of the year.
Frost-resistant EPDM seal
So that valuable heat does not slip through the joints between the panels, they are sealed using EPDM seals. This material does not absorb moisture, differs by elasticity and is able to maintain its properties even when exposed to direct sunlight, precipitation and low temperatures.
The side and upper seals of the "Alutech" gates are two-plates, due to which an additional air chamber is formed and the thermal insulation properties of structures are significantly increased. At the same time, the gate canvas is tightly pressed against seals with adjustable roller brackets - this is another secret to the conservation of heat.
Hidden editing guides
Nicknapper and the corner racks of the "Alutech" gate are mounted behind the gates of indoors, and, therefore, do not contact with cold outdoor air. This solution allows you to minimize heat exchange between the room and the external environment, increasing the thermal insulation properties of the gate.
In general, installing in the garage sectional gates "Alutech", the owners receive structures that guaranteed longer than standard: because they are prepared for temperature drops, protected from freezing and rust. In addition, due to the increased thermal insulation, the gate from the experienced manufacturer allows you to save a round sum on the heating of the garage during the cold season. Gate "Alutech" - the choice of practical hosts.
To obtain additional information about the sectional gates "Alutech", contact the nearest representative of the group of companies in its region.
