The drainage system is necessary to the house: without it, water from the roof eroses the scene and the track, destroys the base and the foundation.
The gutter and the pipes are easiest to install on the final stage of roofing works - when binder eaves. It should be borne in mind that in the winter the system is experiencing extreme loads from the accumulated in the stuffing of ice and somewhat from the roof of snow. Therefore, when installing drains, it is necessary to ensure a triple margin of safety.
Step 1
The brackets of the gutters are allowed to mount to the cornice board. The extreme brackets are exhibited by hydrorer, providing a small slope to the waterfront, and between them stretch the lace. The pitch of the brackets should not exceed 50 cm.
Photo: V. Grigoriev / Burda Media
Step 2.
If the eaves are not yet linked, it is better to attach the brackets from below to the rafter tie. It should be used galvanized, and not blades screws.
Photo: V. Grigoriev / Burda Media
Photo: V. Grigoriev / Burda Media
Step 3.
The main elements of the system - pipes and gutters - often have to be customized in size. It is easy to do with the help of a grinder with any thin cutting disc.
Photo: V. Grigoriev / Burda Media
Step 4.
The ends of the fools are closed with plugs ...
Photo: V. Grigoriev / Burda Media
Step 5.
... and install the waterfront. Some manufacturers equip these elements with a lock connection and rubber gaskets, otherwise you have to use special PVC adhesive.
Photo: V. Grigoriev / Burda Media
Step 6.
It snaps in the brackets or fastened with a special flexible petal.
Photo: V. Grigoriev / Burda Media
Step 7.
It is important that the waterfront is not opposite the bracket.
Photo: V. Grigoriev / Burda Media
Step 8.
It is bile connected with the descent (vertical pipe) by means of two angular taps (their type is chosen, based on the width of the cornese swells) and the short cut pipe.
Photo: V. Grigoriev / Burda Media
Step 9.
The descent is fixed to the wall with special brackets with a turntable clamp, the step of which should not exceed 1 m.
Photo: V. Grigoriev / Burda Media
The more often the brackets are located, the smaller the risk that it will break up under the severity of icicles or snow. However, it is necessary that the cornice board, which is "base" for brackets, itself was firmly applied to the rafters. Photo: V. Grigoriev / Burda Media
PVC manufacturers offer components of different colors, which makes it easier for the task of architect for the design of facades. However, dark products are often not sufficiently rack to ultraviolet: over time they burn out in the sun, acquiring the ashes shade. Photo: V. Grigoriev / Burda Media