The device of the skates and ribs of the pitched roof decorated with a flexible tile Technonikol Shinglas is the final stage to create the roof with the materials of TechnoNIKOL. At the same time, skates and ribs play not only aesthetic role, but also carry a very important function on waterproofing and ventilation of the undercoil space, which means the safety of the whole roof.
In order to high-qualityly mount these elements, a skate-beater tile is used, which is included in the general flexible tile system Technonikol Shinglas. Immediately, we note that for the shapes of the "Sonata" and Trio forms, SHINGLAS, the necessary elements can also be made from the ordinary tile.
Horse-carnice shingles shingles for the convenience of mounting in the factory conditions are separated by perforation into three equal parts.
When installing the edges, the separated elements are attached to the edge of the roof in the direction of bottom up, with the allen on each other 3-5 cm. Each element is attached to a solid base of the roof of four nails - two for each slope, with an indent of 2-3 cm from the edge element. This is a very simple operation that will not take much time.
Photo: Tehtonol
Photo: Tehtonol
After laying the ribs, you can proceed to the last chord - the installation of the skate. It should be noted that the cover is not only the upper horizontal joint of the two planes of the pitched roof, closed with grazing tiles. This is a system for ventilation and removing excess moisture from the underpants space.
Therefore, at first the rib of the skate is installed a special ski aerator TEKNONIKOL. To do this, in a solid foundation of the roof, a cross-cutting gap is made almost all the length of the skate, 5-10 cm wide. Here it is important to take into account two conditions. When the gap device should be closely monitored, so as not to damage the burst structures, and the gap should not reach the edges of the roof on average by 50 cm.
Photo: Tehtonol
Photo: Tehtonol
Photo: Tehtonol
Photo: Tehtonol
Next, put the aerator, which is attached to a solid base of screws. The length of one aerator is 61 cm. When calculating the components, this must be considered. Elements have special latches at the edges for fastening each other.
On top of the aerator, separated elements of the skate-carnice tiles are stacked, curved taking into account the width of the aerator. The elements are attached to the airborne roofing nails with a length of 45 mm, and the flashes are stacked, closing the nice fastening of the previous tile element. The length of the nails cannot be shorter, because they should be securely fixed in a solid foundation of the roof.
Photo: Tehtonol
Photo: Tehtonol
So, the installation of a beautiful and reliable roof with a flexible tile technoNikol Shinglas has been successfully completed.