Overload the camera, forget about the defrost and leave the door to open open - tell what mistakes can reduce the life of your refrigerator.
Once reading? Watch the video!
1 Leave the door open
In the open state on the walls of the chamber, the frost is formed or flies ice, it can harm the compressor fan, not to mention the fact that in such conditions the refrigerator will produce much more cold and spend a lot of energy. The reasons for the open door can be different: you choose the necessary products for too long, we decided to start cleaning the shelves without defrosting the camera, the door looked loosely. Make sure your habits to save the technique in a good longer.
2 Do not follow the door seal
Another problem, due to which warm air penetrates in the fridge, is the deformation of the rubber door seal. It holds the door tightly pressed and helps to keep the cold inside. At the initial stages, cleaning will help. To do this, take hot soap water, wipe the gum, then use a dry towel. After cleaning, lubricate the thin layer of silicone lubricant for rubber seals, if it is not, you can use petroleum. However, if the sealant is deformed strongly, it will be necessary to replace it completely.
Note that regular cleaning of the rubber gasket will help extend its service life.
3 Overload Camera
According to the rules of operation, the refrigeration and freezer chamber should not be filled more than 70%. When we load the fridge 100%, then we have products near the walls of the cameras and depress the important technical holes that you can not do.
4 Do not clean the refrigerator radiator
Any refrigerator or freezer is a radiator (or condenser coils), which takes unnecessary heat. It attracts dust and dirt and ultimately can overheat. Since the radiator most often hides behind the bars or is behind the refrigerator, then it is never thought about cleaning. However, it must be carried out at least twice a year: for this, use the nozzle for the vacuum cleaner and the hard rig for washing dishes.
5 Do not defrost fridge
Many people think that the refrigerators with the NO Frost system are not necessary to defrost, but it is not. According to the rules that can be read in the instructions for the unit, the chambers defrosting are needed 1-2 times a year. Their non-compliance can lead to a breakdown before the term promised by the manufacturer.
If you have a refrigerator of another type, then that it is time to defrost the camera, prompts the ice layer on the walls. If its width reaches one centimeter and more, then it's time to do the refrigerator: disconnect the camera from the network and let it knowy yourself. Do not use sharp items when removing ice: Chopping pieces, you can accidentally damage the compressor or break through the wall.
6 Regularly overload the compressor
Excessive load on the compressor leads to the fact that the device spends a lot of energy and cools the camera is much stronger than necessary. As a result, the products are frozen more, and the device can break. Therefore, you do not need to put inside hot pots, you should not have a refrigerator next to the stove or battery (the distance between them should be at least meter). It is also not necessary to include the coldest temperature regime in hot weather: the compressor will work at the limit of its capabilities and will not last long.
