Do not use the robot vacuum cleaner in the rawrooms, remove the interference from the floor and do not allow complete discharge - tell what rules it is worth sticking to your technique to live longer.
Once reading an article? See a short video on how to extend the service life of the robot vacuum cleaner
1 Do not allow water contacts
Since the robot vacuum cleaner is an electronic device, any contact with water is undesirable for it. Contacts inside it can navigate, or they will cover rust. Therefore, do not run the technique to the floor, if something is spilled, and try not to use in very raw rooms, for example, in the bathroom after taking the soul.Also, if you leave the gadget to work in your absence, make sure that the edge of the table or plate does not cost a complete glass or pan, which can knock on, for example, a cat.
2 Do not let domestic animals
Many animals are beware of moving circles across the floor of the robot and hold aside, and some, on the contrary, try to attack or ride it. In the network you can find a lot of video where cats and dogs use a gadget as a carousel. But still it is not worth it to let them: unforeseen loads sooner or later will disable the system of movement.
3 Confine from falling
If the gadget is used in the house where there are stairs or high podiums, make sure that they have fences that will not let him fall. If, for example, the railing at the stairs is rare and secure the vacuum cleaner, choose a model that, using laser sensors, can make a map of apartments and analyze where the floor ends.You can also purchase a magnetic tape limiter that will be interfered and stop the device.
4 Periodically examine
From time to time, inspect your robot, check if damage did not appear on the wires, does it begin to spoke when charging or strange, jerks, move around the apartment. As soon as the malfunction was noticed - carry it in the service department.
5 Remove interference from the floor
Try to maximize the space for which the vacuum cleaner will move. Basically, the problem for it is carpets with a long pile, lying on the floor wires, children's toys and too much furniture in a small room. Wires can be attached by special holders to the plinth or leg of the desktop, the furniture to move or, for example, buy chairs for the kitchen, which add up to each other. But fluffy carpets, unfortunately, will have to be completely removed, or ease each time before cleaning.6 Brush in time
Explore the instructions for your gadget and stick to the recommended cleaning schedule. The scored filter or garbage collector can lead to a motor brave.
How to clean the technique
- Empty the garbage collector. If it is equipped with a motor, it is impossible to wash it under the jet of water. Shake dust into the trash can and wipe the container well squeezed with a damp cloth. Then again, already a dry cloth so that dust does not stick to the wet surface after cleaning.
- Clear filters. If you have cleaned filters, you need to rinse them at least after each second or third cleaning - it increases its quality. If filters are replaceable, put yourself a reminder of the replacement. You can stick a bright sticker with the last filter replacement date directly to the robot body, so as not to forget.
- Rinse outdoor brushes. Brushes are removed, washed under the crane and wipe off with a dry cloth every week.
- Rub the wheels. Do not forget to sometimes wipe the wheels of the robot - if they are contaminated, it will start to leave the dark stripes.
7 Do not fully discharge
So that the device last longer, let's not discharge it until the end. The optimal way is to deliver the station in an affordable place to charge and set up a robot so that after cleaning it came to her.
