A two-storey house from a glue bar was the answer to all requests to the married couple - his layout took into account not only the hospitality of the owners, but also the possible increase in the family.
A married couple with a little child searched for a local contractor - they needed to design and build a house designed for permanent residence in the Kuusamo community (Northeast Finland). At the same time, the family had already had a number of wishes for the construction. Thus, the cottage was to be a commensurate person of the dimensions, so as not to suppress his own, while there were also small inhabitants, but the layout would take into account the ambulance in the family.
In the summer, two indoor terraces of 45 m2 are at the disposal of the hosts
Guests, and they have often from the owners, also required a place. The optimal offer is a set of relevant inquiries of a volume and spatial solution, a technological "portfolio" and the cost - our heroes made the local company KUUSAMO HIRSITALOT. At the same time, a suitable house could be undertaken by using the finished documentation.
Customers have chosen on the TIVOLA 270 typical project - a two-story residential building, supplemented from the rear facade of large and small terraces. On the first floor of the cottage there was a common space (adjacent volumes of the living room, dining room and kitchen), two guest bedrooms, a wing of technical and bathrooms.
In the sauna there is a traditional wood heater - it is reasonable to consume fuel and faster heats the room steam room
The second floor was fully privatat, the second living room, a bedroom of parents, two children's rooms, a dressing room were designed on it. The project completely satisfied customers - that's except for another childhood until the new child appeared not to furnish.
I did not have any questions and to the technological aspects of the future all-season buildings. The base under the cottage did a warmed Swedish plate. Among the advantages of the support of this type are good thermal insulation, resistance to seasonal adhesions of the soil, plus the possibility of laying engineering communications in the draft floor. It is also important and the other point - the device of the insulated Swedish plate takes a little more than a month, while its cost is 10-15% lower than similar in the characteristics of the belt foundation (at least in Finland).
The outer walls of the two-story cottage were made of 230 × 220 mm from the pine gluing timber. This sawn timber is more durable and stable than solid wood, in addition, above and its thermal insulation capacity. Frame technology was chosen for the inner walls and partitions. The carrying structure is a frame of a segment of 39 × 66 mm - filled with plates of mineral insulation with a thickness of 50 mm, weathered in two layers of GLC. A smooth, which requires a minimum of refinement of plasterboard has become an optimal basis for applying paint, micro-cement, plating wallpaper, trimming of a timber imitation.
Aspects of decor
Walls made of profiled glue vehicles do not need to be design. In this case, they were coated with a colored lesing composition, which emphasized the texture of pine and simultaneously protected it from atmospheric influences. From the inside to all the wooden surfaces of the walls and the ceilings, the paint of white tone was applied. A parquet board with an oak working layer was used as the main flooring. In rooms exposed to strong wear, for example, in the hallway and living room, it was protected by carpets and rugs. In the technical wing for the design of walls and gender, a micro-cement was used.
Heating system
Its base is a heat pump type "Soil-Water", gear ratio in the three-king system of autonomous heat supply. In the first closed contour, which collects low-temperature heat from the soil, circulates non-freezing antifreeze. In the heated state, it enters the second closed circuit - the heat pump. With its help, thermal energy borrowed from the environment enters the third, heating circuit - hydraulic warm floors. For the operation of the heat pump, only electricity is needed (for each kilowat consumed it gives up to 3.5 kW of heat).
In general purpose, a wood fireplace is placed in the common light. In the coldest days, the room is large for the volume in need of additional heating
The enlarged calculation of the cost of arrangement of the house with a total area of 227 m², similar to the *
| Name of works | number | Cost, rub. |
|---|---|---|
| Preparatory and Foundation Works | ||
| Marking axes in accordance with the project, layout, development, recess and backflow of the soil | set | 89 700. |
Sand base device under the foundation | set | 25 800. |
Device of monolithic foundation flat plates with the manufacture of reinforcement frame and installation of formwork | set | 156,000 |
Waterproofing foundation | set | 12 850. |
Thermal insulation of foundation | set | 25 900. |
Other works | set | 15 500. |
| TOTAL | 325 750. | |
| Applied materials on the section | ||
Sand for construction work | set | 25 750. |
Concrete solution, reinforcement, formwork | set | 246,000 |
Waterproofing membrane | set | 43 450. |
Polystyrene foam (200 mm) | set | 109 200. |
Other materials | set | 21 250. |
| TOTAL | 445 650. | |
| Walls, partitions, overlap, roofing | ||
The device of external walls from the profiled glue bar from painting, internal frame walls with insulation and facing | set | 826 450. |
Driving Roofing Flexible Roofing | set | 167 200. |
Installing window and door blocks with sloping finish | set | 234,000 |
Other works | set | 61 400. |
| TOTAL | 1 289 050. | |
| Applied materials on the section | ||
Profiled glue timing segment 230 × 220 mm (pine), paint, natural heater based on wood fiber EKOVILLA (thickness 100 and 200 mm), imitation of timber, gle | set | 801 400. |
Vaporizoation film, natural heater based on Wood fibers Ekovilla (350 mm thick), waterproofing membrane, soft tile icopal | set | 203 050. |
Wooden two-frame Piklas windows, Kaskipuu doors (entrance), Jeld-Wen (interroom) | set | 1 096 600. |
Other materials | set | 105 050. |
| TOTAL | 2 206 100. | |
| Engineering systems | ||
Electric installation work | set | 183 200. |
Installation of heating and ventilation system | set | 396 450. |
Plumbing work | set | 130 650. |
| TOTAL | 710 300. | |
| Applied materials on the section | ||
Materials for electrical work and installation of the lighting system | set | 182 450. |
Equipment and materials for installation of water supply and sewage systems | set | 339 700. |
A set of equipment and materials for mounting the heating system (thermal pump of the type "Soil-Water", water warm floor with ethylene glycol as a coolant) | set | 753 800. |
| TOTAL | 1 275 950. | |
| FINISHING WORK | ||
Wall pastries with wallpapers, flooring from parquet board, plaster, painting and other works | set | 638 200. |
| TOTAL | 638 200. | |
| Applied materials on the section | ||
Sandudd Wallpaper, Osmo Oil, Mic Gearing, Parquet Board, Other Consumables | set | 993 700. |
| TOTAL | 993 700. | |
| TOTAL | 7 884 700. |
* Calculation is carried out without accounting of overhead, transport and other expenses, as well as profit of the company.
Floor plan
Floor Explanation: 1. Hallway 10 m² 2. Living room 26.6 m² 3. Kitchen-dining room 31 m² 4. Guest bedroom 13.3 m² 5. Guest bedroom 16.7 m² 6. Technical premises 17.1 m² 7. Toilet 2.3 m² 8. Shower 5.2 m² 9. Sauna 4.6 m² 10. Guest bathroom 2.1 m²
Plan of the second floor
Explition of the second floor: 1. Hall 7.1 m² 2. Living room 19.5 m² 3. Guest bedroom 9.9 m² 4. Bedroom parents 19.2 m² 5. Wardrobe 9.7 m² 6. Children's room 14.2 m² 7 . Children's room 14.2 m² 8. Bathroom 4.3 m²
Technical data
The total area of the house is 227 m² (excluding area of terraces and summer premises)Designs
Building type: Wooden based on profiled glue bar
Foundation: reinforced concrete stove, horizontal waterproofing - waterproofing membrane, insulation - extrusion polystyrene foam (thickness 200 mm)
Outdoor Walls: Profiled Shaded Bar Section 230 × 220 mm (Pine), Outdoor Decoration - Paint
Inner walls: frame, natural heater based on wood fiber EKOVILLA (thickness 100 and 200 mm), exterior decoration - imitation of timber
Roof: Scope, Multi-Top, Solid Flooring from Profiled Board, Steamproof Warp, Heat - Wood-Fiber Heat Insulation Ekovilla, Applicable by Spraying (Thickness 350 mm), Waterproofing - Waterproofing Membrane, Roof - Bituminous Tiles Icopal
Windows: Wooden two-frame Piklas
Doors: Kaskipuu (exterior), Jeld-Wen (interroom)
Life support systems
Water supply: centralizedSewerage: centralized
Power Supply: Municipal Network
Heating: Geothermal heat pump NIBE type "Soil-Water", Water warm floor with ethylene glycol as a coolant
Ventilation: Natural Supply-Exhaust
Additional equipment: wood fireplace, wood chain KOTA
Interior decoration
Walls: Sandudd wallpaper, Osmo oil, micro
Floors: Parquet Board, Mic Girl