Without sharp corners

The redevelopment of a three-room apartment with a total area of ​​115 m2 is simple and simultaneously original solutions.

In the furniture of the hallway used ceramic tiles, artificial stone, decorative plaster. It overlooks the dining room

In the center of the living room, near the glass coffee table Reflex, the chair and the Valya Sofa are located (both Rolf Benz), covered with skin of creamy

The originality of the interior of the living room gives the author's ceiling lamp and the texture of artificial stone

The passage from the dining room in the kitchen is arranged in the form of an arch. Her ends were told by the MDF panels, the beech veneer. All wheelchair cut point lights

Outlines of oval countertops repeats the lamp Molto Luce. Ktem Tire At different height attached translucent cylinders

Another "window" in the kitchen appeared due to the original ceiling lamp. Kitchen set with beech facades and household appliances Miele

In the bedroom, the smooth line of the tail ceiling descends along the wall and goes into the soft outlines of the carpet made to order from natural cotton. To highlight a plasterboard design, it was covered with decorative plaster Oikos gray-blue

According to the inner edge of the lower level of the undergraduate ceiling, which protrudes is 120 mm, a bertistic is made for the cornice backlight coming around the entire perimeter. For focusing the picture in curly niche above the bed used swivel lamps

To give the bathroom with a strict geometric shape, in the wall next to the plumbing mine equipped niche. Poons placed a boiler of a storage type, as well as a music center and shelves for storing bath accessories

One of the walls lined with monophonic ceramic tiles, decorates the rainbow made of mosaic

Plan before reorganization

Plan after reorganization

The interior that meets the interests of the owner of the housing is not necessarily created according to standard canons. I am always a place of improvisation. Excellent example of this- redevelopment of a three-bedroom apartment. Based on, simple and simultaneously original solutions.

The wishes of the owners of the apartment, expressed by the architect, sounded quite definitely: they wanted the new dwelling would certainly look light, but with bright accents; Ergonomic mutual location was found for spacious premises, and soft scattered light and glass surfaces created a light pleasant atmosphere. To live with comfort, spouses needed a living room, bedroom, office, kitchen, dining room and two bathrooms.

Right route

Some bearing walls were an obstacle to the scheduled reorganization. Rubbing space, Victoria Kovalevskaya sought to place the functional zones rationally relative to each other, and movement routes are comfortable. The center, which combines all the premises, traditionally became the living room. From here leads to the bedroom and in the hallway and in the dining room. Wide arched openings create an effect of openness, so that the dwelling is literally visible through. For example, the one who is in the dining room sees what is happening in the kitchen, living room and lobby. Bowl minimum door. If you do not count the bathrooms and a dressing room, the bedroom is the only isolated room. The door of the adjacent bathroom was originally published in the living room. The architect suffered it, and now in the master's bathroom, you can get directly from the bedroom, when two private zones are interconnected.

Before redeveloping the carrier wall separated the kitchen from the next large room (dining room). The embedded arranged a large arch, the design was reinforced with metal beams, and the entrance to the living room had previously existed. The kitchen with the dining room also combines the podium with a height of 70mm. It performs not only a composite, but also a technical function, because it is hidden the wires of the built-in floor lamps and the heat-insulated floor of Ceilhit (Spain).

The rear speakers of the acoustic system of the Piega home theater system are mounted in the ceiling. This provides the necessary sound quality and at the same time allows you to save the interior from unnecessary technical accessories. For installation, assembly boxes were used, which were built into the metal frame of the casing drywall design. Outside around the perimeter, the devices were closed with decorative lattices.

Another substantial innovation is the transfer of the wardrobe. First, it was located between the guest bathroom and the hallway, and now it takes the left corner of the dining room, improving the perception of a disproportionately elongated room. When the location of the dressing room has changed, the size of the bathroom increased, he acquired the form of the sector, and the passage from the hall in the living room became wider, parade.

Artificial stone is attached to the wall on the "Liquid nails" - construction glue based on rubber and polymers, designed to be connected to both homogeneous and heterogeneous building materials. Building scotch closed the visible end surfaces of the stones, especially thoroughly in the adjoining zone, so as not to stain them when painting the wall.

In order not to reduce the area of ​​other rooms, the architect advised not to divert a separate room under the office. This problem was solved through an elegant compromise: the modern Bureau Reflex (Italy) acquired, within which it is possible to compactly place the computer, the necessary paper, stationery. When urgent matters are finished, it is enough to close the doors- and the working disorder is no longer bothering anyone. Mobile office everyone perceived with pleasure.

Material for fantasy

New partitions were built from plasterboard on a metal frame. According to the architect, it is quite durable and reliable material. In compliance with the technological requirements for installation, it is characterized by high characteristics. So, 1Pog. Mooles from the GLC withstands the load to 10kg, so it can be glued to the ceramic tiles and even hang the shelves (of course, not book). Other important arguments in favor of drywall were lower costs and the complexity of the device of radius walls from it compared, for example, using building blocks or bricks.

The inhouse built three rounded walls - smooth outlines have a guest bathroom, a dressing room and one of the corners on the path from the hallway to the dining room. Each of these partitions on both sides were performed from two layers of plasterboard with a thickness of 12.5 mm. Soundproofing - "Shumannet" ("Acoustic Materials and Technologies", Russia), a filling gap of 20mm, was made between the inner and outer skin. As a result, the wall thickness was 70mm, which is less than the similar parameter of the structure of the brick and the more of the foam blocks. In addition, the elasticity of GLC is higher than that of these materials, and this is important for the new house, which can give shrinkage.

Glass protects bricks

The kitchen "apron" is traditionally separated by ceramic tiles so that it is easy to eliminate fat stains and splashes, inevitably appearing during cooking and washing dishes. Instead of the trivial decision, the architect proposed a clinker facing brick. This material with a solid smooth surface is used for external work, and in the interior, it not only performs a protective function, but also decorates the room.

The brick was laid in a shallow niche made in a reinforced concrete wall. A piece of decorative masonry near the cooking panel was closed with a transparent fire-resistant glass of 9mm thick. Protective glass sheets secured with thick screws with wide steel heads.

The simplicity of the gaskets also relates to the advantages of plasterboard partitions. It is easy to make holes through which the wires going inside the walls are outwardly in the right place. To ensure complete safety and insulation of the electrical network, the wires were hidden into protective corrugated tubes with a diameter of 16mm.

Unusual ceilings

In all the premises of the apartment, there were stitched plasterboard ceilings on a metal frame, and for each of them managed to find a rather original solution. Vcridor created a design with highlighted square caissons. Their side walls are made of GLC, and the bottom serve well plastered areas of the surface of the reinforced concrete interhesion. Inside each excavation directly to the concrete ceiling, not to reduce the height of the room, the lamp is attached 220V (Primolux, Germany). Light sources are connected consistently.

Light top

From the plane of the ceiling protrude volumetric glowing boxes, characterized by a futuristic design, are five parallelepipeds in the center and a strip going around the perimeter. This courageous solution is perfectly combined with a ceramic bright-salad ceramic tile, which the walls of the room are lined on top of the bottom.

Translucent milk plastic gently dispels the light of halogen lamps having protection against moisture and working with a standard voltage of 220V. The choice of light sources is dictated by practical considerations. Thus, when using low-voltage lamps, a transformer is inevitably inevitably, which must be placed behind the dry-carcarter design. The device may fail, so it is necessary to provide access to it. In order to avoid problems, sources with a voltage of 220V are used.

The busty plane of the tail ceiling decorates the original lamp made to order. It is made of plexiglas framed by aluminum profile, and is attached to the intergenerational overlap with metal suspensions. For him, luminescent tubes of different lengths are selected. In tasteless and guest baths of plexiglas in the aluminum profile, made by the same principle. They are embedded in "drywall" and hold onto a reinforced concrete plate through suspensions.

The plasterboard ceiling in the living room is 15cm, so the technical parts of the columns and lamps are hidden inside. On the perimeter of the zone passes the cornice backlight. To arrange it, the sheets of GLCs were silent so that they do not reach the walls at 12 cm, and on their inner surface on the edge of the cornice made sides. Thanks to this, the halogen lamps Paulmann (Germany) are not visible.

Cost of preparatory and installation work

Type of work	Scope of work	Rate, rub.	Cost, rub.
Dismantling and preparatory work	-	-	18 900.
Employ device (with metal)	-	-	15 700.
Device partitions from GLC	53m2.	-	28 400.
Device of ceilings and decorative parts from GLC	-	-	77 500.
Loading and removal of construction trash	3 containers	-	11 400.
TOTAL	151900.

Cost of materials for installation work

Name	number	price, rub.	Cost, rub.
Steel rental, consumables	set	-	5300.
Plasterboard sheet, profile, screw, ox ribbon, sound insulation plate	set	-	36 700.
Polypropylene bag for construction waste	80 pcs.	10	800.
TOTAL	42800.

Cost of work on the device of floors

Type of work	Area, m2	Rate, rub.	Cost, rub.
Device of coating waterproofing	115.	135.	15 525.
Concrete screed device, podium	115.	-	40 500.
Device of bulk coatings	72.	162.	11 664.
Installation of flooring coatings	72.	320.	23 040.
Installation of ceramic tile coatings	43.	-	26 800.
TOTAL	117530.

Cost of materials for flooring device

Name	number	price, rub.	Cost, rub.
Waterproofing (Russia)	400kg	65.	26 000
Soil, Peskobeton, Ceramzit, Mesh	set	-	48,000
Floor Rover (Russia)	360kg	10	3600.
Parquet board	72m2	1460.	105 120.
Ceramic tile, glue, grout	set	-	44 800.
TOTAL	227520.

The cost of finishing work

Type of work	Area, m2	Rate, rub.	Cost, rub.
Watching surfaces	270.	-	87 500.
Coloring surfaces, decorative stucco finish	195.	390.	76 050.
Facing the walls with ceramic tiles, stone	58.	-	40 800.
Carpentry, carpentry work	-	-	39 800.
TOTAL	244150.

The cost of materials for the production of finishing works

Name	number	price, rub.	Cost, rub.
Plaster Gypsum, Soil, Putclone	set	-	38 300.
Paint V / d, decorative coating	set	-	12 400.
Ceramic tile, stone	58m2	-	52 800.
Tile glue	11 bags	600.	6600.
TOTAL	110100.

The cost of electrical work

Type of work	Scope of work	Rate, rub.	Cost, rub.
Installation of wiring, cable	870 M.	-	36 600.
Installation of power and low-current	set	-	7600.
Installation of switches, sockets	45 pcs.	280.	12 600.
Installation, suspension of lamps, chandeliers	-	-	19 800.
Installation of floor heating system	set	-	5200.
TOTAL	81800.

The cost of electrical materials

Name	number	price, rub.	Cost, rub.
Electric -, telephone, antenna cables and components	870 M.	-	20 900.
Electrical, protective shutdown devices, automata	set	-	9300.
Wiring accessories	45 pcs.	-	11 900.
Floor heating system (cable, thermostat, sensors)	set	-	16 200.
TOTAL	58300.

Cost of plumbing work

Type of work	Scope of work	Rate, rub.	Cost, rub.
Laying water supply pipelines	43 pog. M.	180.	7740.
Laying of sewage pipelines	18 pog. M.	-	1980.
Collector installation, filter	set	2800.	2800.
Installation of Santechniborov	set	-	21 400.
TOTAL	33920.

Cost of plumbing materials and installation devices

Name	number	price, rub.	Cost, rub.
Metal Pipes (Germany)	43 pog. M.	-	2580.
Sewer PVC pipes, angles, taps	18 pog. M.	-	2450.
Distributors, Filters, Fittings	set	-	19,700
Bath, shower, toilets, washbasins, faucets	set	-	138 300.
TOTAL	163030.

The editors warns that in accordance with the Housing Code of the Russian Federation, the coordination of the conducted reorganization and redevelopment is required.

Architect: Victoria Kovalevskaya

Watch overpower