The outer decoration of the walls of the bath is made in the so-called trim style that promotes the unity of the appearance of the house and the surrounding landscape. To achieve this harmony, wooden tiles are used (shingles, duch, lemhech, sindel), which the facade and (or) are covered with a roof of the building. Gonf is made of pine, larch, spruce, aspen, oak or beech small planks having a wedge-shaped section.
The secret of the durability of the racing roof is both in the peculiarities of the material and in the technology of its laying. Manufacturing a shingle is carried out manually. When splitting blanks on the surface of the chip, the intermolecular bonds of wood is not disturbed, therefore the service life of products increases several times compared with sawing elements of coatings. Hands are produced in size than 35-80cm in length and 6-12cm in width. Sweet rib make trapezoidal grooves.
Usually, the shings are used for roofing wooden houses with a roof slope 18-60. The square meter of such a coating weighs 15-17kg, because it does not need to build a heavy crate. After the manufacture of the rafter design, the boardy flooring was built from the edged lumber, put the underfilm film. (If this is a attic, additionally insulate the attic space.) On the flooring along the rafter, the counterclaim and the crate, on which the shingle down the horizontal rows is close to the bottom of the horizontal rows. Products have three-layers. When laying, the thin edge of one plate is included in the groove of the thick edge of the other, ensuring the connection strength.
Working on a bath, which we are talking about, Architect Igor Alekseev retreated from traditional technology, which not only facilitated the task, but also gave the individuality design of wall decoration. The material for the manufacture of a shingle was a pine block house. The boards were coated with an antiseptic from Pinotex and painted into a noble color of teak tree. The wood did not split, and saw on a table with a length of 35cm, 8cm wide and 1.2 cm thick. Hands mounted on the walls of the Bani Machine with one layer over the pre-made crate.