If, after pressing things, water is still raw or in the tank, water remains, then the washing machine stopped dragging water. We tell and show how to fix this problem.
The machine may not merge water due to the drain pump, in this case the help of specialists will need. But do not hurry to call the repairmen, perhaps the reason will be able to eliminate your own forces.
1 Check the filter
First of all, check the condition of the filter in the washing machine. It is usually located behind the hinged door at the bottom of the case.
The filter is unscrewed counterclockwise.
Be careful: Keep in mind that when the filter is unscrewed, 100-150 ml of water flows. It is better to substitute in advance for a filter any low container for collecting fluid (there will be very comfortable baths for photo printing).
So he is filter. In good condition, it was recently cleaned. There was a button.
2 Inspect the drain hose
The next step is inspecting the drain hose. There is no inflection if any of the households have any heavy package with a washing powder.
3 Clean the siphon
After checking, disconnect the hose and disassemble the siphon. This is dirty work - stock bucket for collecting water. Unscrew the sump (at the bottom of the siphon), drain the water and clean the siphon.
4 Arrange checksum for machine
After cleaning, it makes sense to make sure that the washing machine normally drains water. Hang the drain hose to the edge of the bath or sinks and put some short program on the washing machine (rinse + spin in 15 minutes).
A few minutes later the hose begins to drain the water. The water pressure in the stream is normal, it means that the pump in the car is working. After cleaning the siphon, the machine began to normal with water normally. If this does not happen, most likely you have a sewer pipe.
