The wooden table lamp body can simultaneously serve as a column for CDs. The decoration "under marble" gives the product a special charm.
The original table lamp housing is simultaneously a column for laser disks. You can pick up a lamp shade for him in accordance with your interior style. This is a good reason to join homemade creativity. We are talking about the column for fifteen CDs: ten simple and five double. But you can make any required amount of cells, pick up the lampshade of suitable size.
On the inside of the sidewall, mark the position of the reference planks under the CD. The reference bar with a cross section of 44mm is equal to 14cm. Since the box for one CD has a thickness of 11mm, and for two- 29mm, the distance between the planks should be 1-2mm more. Shedding sidewalls should be performed at the same time, folding them with the edges. This will ensure the perfect symmetry of the grooves. Carnations (12mm) Singing the bar so that they defend the sidewall to 6mm from the front edge.
Details of the lamp housing are connected using glue and screws. Speakers on 10mm edges of the base are separated by a semicircular baguette and an angular lining. The edges of the lid are also combined with a semicircular baguette. In the center of the lid, it is necessary to drill a hole to fix the lamp cartridge.
Choosing finishes
For registration of the lamp housing, you can apply a smooth or plot painting, color or colorless varnishing, any other finish, including the imitation of marble. Having made your choice, bow to fine-dispersed putty, paint tubes, solvent, tampon and good tassels.
| So that the support barns were the same size, stick the metal line with a sticky ribbon to the table, marking it 14cm. Planks with a cross section of 44mm easily cut the shoe knife. |
| Sweep the support bar to the sidewalls, folding them with the edges. To accurately withstand the distances between the planks, use two struts width 30 and 12mm (for double and single compact discs). |
| Connect the sidewalls and rear wall with the help of glue and screws with a secret head (2.516mm size, from stainless steel or brass). To withstand perpendicularity, install two struts between the sides, then impose a cargo. |
| Before you put the lid on the screws, fix it with several nails. For a more accurate installation of the base, type the two technological planks 1010mm and use them as stops. |
| Thoroughly measured, pump up at the angle of 45 semicircular bagent strips. In the same way, but at an angle of 90 disconnect flat lining for the base. Slide glue and quit them (lining) cloves to the base of the walls. |
| Now fasten the semicircular baguette around the base, paying attention to the joints. You can pre-put tags to facilitate the following actions. |
| The angular linings are installed on the edge of the base and are joined in an angle 45. The rear pad is cut on both sides, lateral and one. |
| Having finished the base, secure the semicircular baguette on the cover, the hole is pre-drilled in its center with a diameter of 10mm to install the cartridge. |
| At the end, treat all the product and carefully remove the dust carefully. Flat brush width 20-25mm apply a fine spacing. See her well. |
| Polish the covered surfaces of the water abrasive suspension. At your own discretion, the composition of white, golden yellow or reddish-yellow paints. Radibly rude paints with a tampon. |
| Apply a streak by saving a brush into a diluted paint solvent of two different colors: golden (light) and red-brown (dark). Lines must be uneven and one direction. |
| You can emphasize the accommodation, drawing them a thin brush. Then, apply the tampon. Finish the decoration of the decisive, widely by a soft brush over the entire surface. |
| There should be sufficient space between the mounting thread of the carrier rod and the cartridge. This will give the lamp elegance, increase the illumination zone and remove the heat source from the CD. |
